Canon CXDI-50G Service Manual page 70

Kodak Imation DryView
8700+9440
Kodak Imation Dry View
8500+
Nishimoto EL2000N
2. Installation Manual
-A 320 -T NO -M CUBIC –S
"LUT=m, n"-m (on-site
adjustment)
(entered in param member)
78 (entered in pixelPitch
member)
4096 (entered in W member)
5220 (entered in H member)
The model 8800 has a rotation
function but we understand
that Imation has not publicly
acknowledged the use of this
function.
-A 310 -T NO -M CUBIC -m
? -S LUT=0?, 2? (?: Site
Dependent)
(entered in param member)
78 (entered in pixelPitch
member)
14x17
3388 (entered in W member)
4277 (entered in H member)
-A 320 -T NO -M CUBIC -S
15
(entered in param member)
80 (entered in pixelPitch
member)
4444 (entered in portraitW
member)
5296 (entered in portraitH
member)
5296 (entered in landscapeW
member)
4444 (entered in landscapeH
member)
"Prepare images using CXDI"
: Yes
A simple calculation yields a
resolution of 4444 x 5400 for
the display area of the model
EL2000. However, 5376@80
µm is set in the perpendicular
direction of the model EL2000
since the maximum size of the
CXDI images is 2688@160
µm. In this case, a small non-
image area should be output as
the border in the up/down
direction on the film according
to the calculation. In actual
fact, however, the image will
protrude in some cases
depending on how the
transport speed and other
- 56 -
• The Kodak service engineer is
responsible for setting the smoothing
type on-site since it can be changed with
each printer.
• The rest is done by the printer itself.
• Trimming OFF
• Cubic spline interpolation
• Maximum density: 3.20
• S LUT = m, n is designated as the
Config Info but m and n are adjusted on-
site by the Kodak service engineer.
Basically, adjustment is performed to
achieve a linear output.
• The Kodak service engineer is
responsible for setting the smoothing
type on-site since it can be changed with
each printer.
• The rest is done by the printer itself.
• Trimming OFF
• Cubic spline interpolation
• Smoothing must be adjusted at the user's
site.
• Maximum density: 3.10
• -S
• LUT = m, n is designated as the Config
Info but m and n are adjusted on-site by
the Kodak service engineer. Basically,
adjustment is performed to achieve a
linear output.
• Trimming OFF
• Cubic spline interpolation
• Maximum density: 3.20
• "15" in Config Info is linear.
• The rest is done by the printer itself.
Up to 5376 pixels can be set for H.