Beretta EXCLUSIVE R Installer And User Manual page 25

Closing
position
5.20 System reset
b
This operation must be carried out only by professionally qualified
personnel.
Whenever necessary, it is possible to restore the factory settings by
carrying out a SYSTEM RESET:
- access the technical parameters as explained in the section "4.1 Access
to the technical parameters"
- select INSTALLATION with the "up" and "down" keys, confirming the
selection
INSTALLATION
PARAMETERS
THERMOREGULATION
RANGE RATED
CALIBRATION
INSTALLER
- select SYSTEM RESET with the "up" and "down" keys, confirming the
selection
ZONES MANAGER
SENSOR CALIBRATION
SYSTEM RESET
INSTALLER
- select CONFIRM to conform the system reset or else CANCEL to cancel
the operation.
Note: after a reset it is necessary to carry out a new configuration of the
system; for details about this procedure, see the following section.
TECHNICAL
INSTALL
CONFIRM
CANCEL
5.21 System configuration
b
This operation must be carried out only by professionally qualified
personnel.
When restarting after a replacement of the REC10 rather than after a
"SYSTEM RESET", the remote control displays an initial screen with
the firmware revision. Pressing "ok" a guided procedure is started for
configuring the system; select the desired options with the "up" and "down"
keys, confirming the selections made:
MULTI ZONE CONTROLLER
REC10 V01.26
PRESS ANY KEY
TO CONTINUE
- LANGUAGE selection:
ENGLISH
ITALIANO
- setting TIME and DATE
TIME & DATE
ENTER TIME AND DATE
12
18 / 11 / 2013
USE THE ARROWS TO MODIFY
- setting the operating mode of the REC10:
MASTER: select this option when the REC10 is also a MACHINE
INTERFACE.
- configuration selection:
FROM AKM: to reset the current boiler configuration on REC10 MASTER
and finish the operatione
NEW: to set a new system configuration restoring the factory setting of
the parameters
OF CONFIGURATION
ENGLISH
ITALIANO
: 17
SELECT THE TYPE
FROM AKM
NEW
ENGLISH
25