Table 5-16: Execution Error - Tektronix MTD200 User Manual

MTD200 MPEG Test Decoder User Manual
Table 5–15: Command errors (cont.)
Error Error text returned upon queue query
number Explanations
–141 Invalid character data
Either the character data element contains an invalid character or the element
received is not valid for this command.
Example: spelling mistake in parameter specification.
–144 Character data too long
The character data element contains more than 12 characters.
–148 Character data not allowed
A legal character data element encountered was not allowed for this command or at
this position of the command.
Example: command SENSe:PROGram requires a numeral to be specified.
–151 Invalid string data
Command contains invalid string data.
Example: an END message was received before the terminal quote character.
–158 String data not allowed
The command contains a legal string data element at a position where it is not
allowed.
Example: character data in quotation marks.
–168 Block data not allowed
The command contains legal block data at a position where they are not allowed.
–171 Invalid expression
Command contains an invalid expression data element.
Example: the expression contains unmatched parentheses.
–178 Expression data not allowed
A legal expression data was encountered at a position where it is not allowed.
Execution Error (error encountered during command execution that causes bit 4
in the ESR register to be set).
Table 5–16: Execution error
Error Error text returned upon queue query
number Explanations
–200 Execution error
Error encountered upon command execution (eg printer has run out of paper).
–221 Settings conflict
There is a setting conflict between two parameters.
Example: In the DUMP mode, monitoring cannot be started when MONITORING is
selected.
–222 Data out of range
The data element was outside the legal range as defined by the device.
Example: command SENSe:PROGram allows entries only in the range 1 to 65535.
Remote Control
5–65