About The Demo Mode; Reverse Mode; Feature Demo - Pioneer ANH-P9R-BK Operation Manual

Section
Before You Start
01
Notes
• When using with a Pioneer Navigation
System, if you press
OFF is selected. If ACC ON is selected, correct
operation may not be possible even if you
press .
RESET
• After completing connections or when you
want to erase all memorized settings or return
the unit to its initial (factory) settings, switch
your engine ON or set the ignition switch to
ACC ON before pressing

About the demo mode

This product features two demonstration
modes. one is the reverse mode, the other is the
feature demo mode.

Reverse mode

If you do not perform an operation within about
30 seconds, screen indications start to reverse,
and then continue reversing every 10 seconds.
Pressing 5 numbered button when power to this
product is switched off while the ignition switch
is set to ACC or ON cancels the reverse mode.
Pressing 5 numbered button again to start the
reverse mode.
12
En
, be sure the ACC
RESET
.
RESET

Feature demo

The feature demo automatically starts when
power to this product is switched off while the
ignition switch is set to ACC or ON. Pressing 6
numbered button during feature demo opera-
tion cancels the feature demo mode. Pressing 6
numbered button again to start the feature
mode. Remember that if the feature demo con-
tinues operating when the car engine is
switched off, it may drain battery power.
Notes
• You cannot cancel a demo mode when the
front panel is open.
• The red lead (ACC) of this product should be
connected to a terminal coupled with ignition
switch on/off operations. If this is not done,
the vehicle battery may be drained.
• When the source is off, you can check the
location of "5" and "6" by turnig on the feature
demo.