Clearing All Memory; About The Demo Mode; Reverse Mode; Feature Demo - Pioneer DEH-P70BT Operation Manual

Before You Start

Clearing all memory

To protect personal and private information,
data about the phone stored in this unit can
be deleted.
1 Remove the front panel.
2 Press EJECT and RESET simultaneously.
3 Replace the front panel by clipping it
into place.
4 Turn the ignition to ACC or ON and
wait until the feature demo appears in the
display.
All memory is now completely cleared.
# Please confirm if all data have been comple-
tely cleared. For confirmation of the data status,
refer to Registering your cellular phone featuring
Bluetooth on page 42. If all phones statuses are
No data, data has been completely cleared.

About the demo mode

This unit features two demonstration modes.
One is the reverse mode, the other is the fea-
ture demo mode.
! You cannot cancel a demo mode when the
front panel is open.
Important
The red lead (ACC) of this unit should be con-
nected to a terminal coupled with ignition switch
on/off operations. If this is not done, the vehicle
battery may be drained.

Reverse mode

If you do not perform an operation within
about 30 seconds, screen indications start to
reverse, and then continue reversing every 10
All manuals and user guides at all-guides.com
seconds. Pressing button 5 when power to
this unit is turned off while the ignition switch
is set to ACC or ON cancels the reverse mode.
Press button 5 again to start the reverse
mode.
! You can also perform the same operation
from Switching the reverse mode on Initial
Settings. For more details, see Switching
the reverse mode on page 82.

Feature demo

The feature demo automatically starts when
power to this unit is turned off while the igni-
tion switch is set to ACC or ON. Pressing but-
ton 6 during feature demo operation cancels
the feature demo mode. Press button 6 again
to start the feature mode. Remember that if
the feature demo continues operating when
the car engine is turned off, it may drain bat-
tery power.
! You can also perform the same operation
from Switching the feature demo on Initial
Settings. For more details, see Switching
the feature demo on page 81.
Use and care of the remote
control

Installing the battery

Remove the cover on the back of the steering
remote control and insert the battery with the
plus (+) and minus () poles pointing in the
proper direction.
! When using for the first time, pull out the
film protruding from the tray.
Section
01
11
En