Setting The Warning Tone; Switching The Rear Output Setting - Pioneer ANH-P9R-BK Operation Manual

Initial Settings
Button Tuning step
50K 50 kHz
100K 100 kHz
Notes
• The FM tuning step remains set at 50 kHz
during manual tuning.
• The tuning step returns to 100 kHz if the bat-
tery is temporarily disconnected.

Setting the warning tone

The warning tone sounds to remind you to
detach the front panel. (Refer to page 11.)
You can turn the warning tone function on or off.
1 With the source turned off, press and hold
1.
2 Press and then press
NEXT
select the warning tone mode.
3 Press to turn the warning tone on.
DT-WRN
appears in the display.
ON
• Press again to turn the warning tone
DT-WRN
off.

Switching the rear output setting

This unit's PREOUT (rear speaker leads output
and RCA rear output) can be used for full-range
speaker or subwoofer connection. If you switch
the PREOUT setting to the subwoofer, you can
connect a rear speaker lead directly to a sub-
woofer without using an auxiliary amp.
• If you connect a subwoofer to the rear output,
• Even if you change this setting, there is no
• Both rear speaker leads output and RCA rear
1 With the source turned off, press and hold
2 Press
select the preout setting mode.
3 Press
to
DT-WRN
output setting.
set the output setting to
output unless you switch the subwoofer out-
put on (refer to Using subwoofer output on
page 79).
output are switched simultaneously in this
setting.
1.
and then press
NEXT
or to select the desired
SW REAR
Section
.
SW
to
PREOUT
En
11
83