Using The Remote Control; About The Demo Mode; Resetting The Microprocessor - Pioneer SUPER TUNER III D FH-P4200MP Operation Manual

Before You Start

Using the remote control

Point the remote control in the direction of the
front panel to operate.
Important
! Do not store the remote control in high tem-
peratures or direct sunlight.
! The remote control may not function properly
in direct sunlight.
! Do not let the remote control fall onto the
floor, where it may become jammed under the
brake or accelerator pedal.

About the demo mode

The demonstration automatically starts when
power to this unit is turned off while the igni-
tion switch is set to ACC or ON. Pressing 6
numbered button during demonstration can-
cels the demonstration. Pressing 6 numbered
button again to start the demonstration. Re-
member that if the demonstration continues
operating when the car engine is turned off, it
may drain battery power.
Important
The red lead (ACC) of this unit should be con-
nected to a terminal coupled with ignition switch
on/off operations. If this is not done, the vehicle
battery may be drained.

Resetting the microprocessor

The microprocessor must be reset under the
following conditions:
! Prior to using this unit for the first time
after installation
! If the unit fails to operate properly
All manuals and user guides at all-guides.com
! When strange or incorrect messages ap-
pear on the display
% Press RESET on the head unit with a
pen tip or other pointed instrument.
RESET button
Section
01
7
En