Using Subwoofer Output; Adjusting Subwoofer Settings; Adjusting Source Levels - Pioneer ANH-P9R-BK Operation Manual

Audio Adjustments

Using subwoofer output

This unit is equipped with a subwoofer output
which can be switched on or off. When a sub-
woofer is connected to the rear output, first,
switch the rear output setting to subwoofer,
then turn the subwoofer output on. For more
details, see Switching the rear output setting on
page 83.
1 Press and
AUDIO NEXT
to select the subwoofer output mode.
2 Press to turn the subwoofer output on.
SW1
"SUB. W ON" appears in the display.
• Press again to turn subwoofer output off.
SW1

Adjusting subwoofer settings

When the subwoofer output is on, you can
adjust the cut-off frequency and the output level
of the subwoofer.
1 Press and
AUDIO NEXT
to select the subwoofer setting mode.
When the subwoofer output is on, you can
select the .
SW2
2 Press 2 or 3 to select the cut-off
frequency.
Each press of 2 or 3 selects cut-off frequencies
in the following order:
50 — 80 — 125 (Hz)
3 Press 5 or ∞ to adjust the output level of
the subwoofer.
Each press of 5 or ∞ increases or decreases
the level of the subwoofer.
• "+6" – "–6" is displayed as the level is
increased or decreased.
and then press
SW1
and then press
SW2
Note
• "SW2" is not displayed when the subwoofer
output is off in the subwoofer output mode
(SW1). In this case, this mode is inactive.

Adjusting source levels

SLA (source level adjustment) lets you adjust
the volume level of each source to prevent radi-
cal changes in volume when switching between
sources.
• Settings are based on the FM tuner volume
level, which remains unchanged.
1 Compare the tuner volume level with
FM
the level of the source you want to adjust
(e.g., built-in CD player).
2 Press and then press
AUDIO
3 Press to select the
SLA
4 Press 5 or ∞ to adjust the source volume.
Each press of 5 or ∞ increases or decreases
the source volume. +4 – –4 is displayed as the
source volume is increased or decreased.
Notes
• Since the FM tuner volume is the control, it is
not possible to apply source level adjustments
to the FM tuner.
• The MW/LW tuner volume level can also be
adjusted using source level adjustment.
• The built-in CD and the multi-CD players are
both set to the same source level adjustment
volume automatically.
• External unit 1 and External unit 2 are set to
the same volume adjustment setting automat-
ically.
Section
.
NEXT
mode.
SLA
79
En
10