Drive System - Siemens SIMODRIVE 611 digital Configuration Manual

Forword
!
!
viii
www.aotewell.com
Warning
When electrical equipment is operated, certain parts of this equipment are
inevitably under dangerous voltage.
Incorrect handling of these units, i.e. not observing the warning information, can
therefore lead to death, severe bodily injury or significant material damage.
Only appropriately qualified personnel may commission/start up this
equipment.
These personnel must be thoroughly familiar with all warnings and
maintenance procedures described in these operating instructions.
Perfect, safe and reliable operation of the equipment assumes that it has been
appropriately transported and repaired and professionally stored, mounted and
installed as well as carefully operated and serviced. Failure to observe these
requirements can endanger the user (electrical shock, fire hazard) or damage
the device.
Hazardous axis motion can occur when working with the equipment.
Further, all of the relevant national, local land plant/system–specific regulations
and specifications must be taken into account.
Caution
The DC link discharge voltage hazard warning in the local language must be
clearly attached to the appropriate modules.
Note
When handling cables, please observe the following:
S
are not damaged
S
they may not be stressed,
S
they may not come into contact with rotating components.
Notice
M600 and M500 are not PE voltages. Hazardous voltages of between
300 ... 400 V with respect to PE are present at the terminals. These potentials
(voltages) may not be connected to PE.
Note
The machine builder must ensure that the voltage drop between the start of the
consumer's installation and the power drive system (PDS) does not exceed 4%
when operating with rated values.
SIMODRIVE 611 Configuration Manual (PJU) – 05/2008 Edition
sales@aotewell.com
Industry Automation
© Siemens AG 2008 All Rights Reserved
+86-755-8660-6182
05.08
05.01