Siemens SIMODRIVE 611 digital Configuration Manual page 168

6 Infeed Modules
6.4 HFD reactor
Damping resistor
6-168
www.aotewell.com
Together with the HFD reactor, an external resistor must be used for damping
purposes (refer to Fig. 6-11).
Table 6-8 Technical specifications
Pulsed resistor
Order No. 6SN1113- -1AA00- -
0DAV
Rated power (kW)
Special low- -inductance
resistor
including the connect-
ing cable [m]
Connection
Weight [kg]
Degree of protection
acc. to DIN EN 60529
(IEC 60529)
UL file
Ambient temperature
[°C]
Dimensions (W x H x
D) [mm]
1) The 300 W resistance can be used for HFD applications if
the following is true after a warm- -up run when all axes are shut down in a regulated way:
S
After an operating period of over two hours, no temperature in excess of 150 _C
may occur on the surface of the 6SN1113- -1AA00- -0DA0 resistor.
S
This warm- -up run must be repeated if the hardware configuration, e.g. motor cable
lengths, is changed!
2) Preferred type
3) Alternative possible
Note
Preferably, the HFD damping resistor (6SL3100--1BE21--3AA0) should be
used. It must not be connected as an external pulsed resistor on the pulsed
resistor module or UI module!
The HFD damping resistor can become very hot. Consequently, it must be
installed so that it cannot be touched or placed at an endangered position with
an appropriate warning notice.
Reader's note
For mounting information and instructions for external HFD resistors, refer to
Fig. 6-11 and Chapter 6.7.4.
SIMODRIVE 611 Configuration Manual (PJU) - - 05/2008 Edition
sales@aotewell.com
HFD damping re-
1)
0.3/25 kW sistor
6SL3100- -1BE21- -
3AAV
0.3 0.8
0...230 kHz 3 dB
3 5
2
3 x 1.5 mm 4 x 1.5 mm
1.45 5.5
IP 54 IP51
E- -228809 E- -212934
0...55
80 x 210 x 53 277 x 552 x 75
© Siemens AG 2008 All Rights Reserved
Industry Automation
11.05 05.08
05.01
Pulsed resistor
2) 3)
Plus 1.5/25 kW
6SL3100- -1BE22- -
5AAV
1.5
5
2 2
4 x 2.5 mm
5.6
IP20
E- -192450
193 x 410 x 240
+86-755-8660-6182