Siemens SIMODRIVE 611 digital Configuration Manual page 106

5 Control Units
5.1 Closed–loop control with digital setpoint interface
1–axis version
High Performance
M3/0.8 Nm
0.5 Nm
DAC assignment
DAC 1 DAC 2
DAC 3 Ground
Fig. 5-2 Digital control High Performance and High Standard without direct measuring system
!
5-106
www.aotewell.com
DAC assignment
DAC 1
DAC 3
M3/0.8 Nm
Notice
When using non–PELV circuits at terminals AS1, AS2, connectors must be
coded to prevent the connectors being incorrectly inserted (refer to
EN60204–1, Section 6.4).
For the order number for coded connectors, refer to Catalog NC 60.
Warning
At terminals 19, P24 and M24, only PELV circuits may be connected. If this is
not carefully observed, then this can result in personal injury in the form of
electric shock.
SIMODRIVE 611 Configuration Manual (PJU) – 05/2008 Edition
sales@aotewell.com
2–axis version
High Performance/High Standard
M3/0.8 Nm
0.5 Nm
DAC 2
Ground
© Siemens AG 2008 All Rights Reserved
Industry Automation
11.05
05.01
+86-755-8660-6182