Siemens SIMODRIVE 611 digital Configuration Manual page 175

Aotewell Ltd
05.08 11.05
05.01
Table 6-11
Term. Desig-
No. nation
111 X161
213 X161
2)4)
9 X141B
112 X141B
48 X141B
NS1 X141B
NS2 X141B
15 X141B
1) I = input; O = output; NC = NC contact; NO = NO contact
2) Term. 19 is the reference ground (connected through 10 kΩ to the general reference ground X131 inside the module)
Terminal 15 must not be connected to PE, to terminal 19 or to external voltage sources
Terminal 19 can be connected to X131.
The terminal may be used exclusively for enabling the associated drive group.
3) The grounding clip is used to ground the DC link M busbar through 100 kΩ (must be closed;
the grounding clip must be opened if the system is subject to a high- -voltage test).
4) max. current load of terminal 9 - - terminal 19 ± 1 A
Notice: For the 5 kW, there are no terminals 7, 45, 44 and 10.
5) RESET = resets the fault memory, edge- -triggered for the complete drive group
(terminal "R" ! Term. 19 = RESET)
6) For UL certification
7) In accordance with EN 60204- -1 (machine safety),
control transformers must be used for AC control voltages.
© Siemens AG 2008 All Rights Reserved
SIMODRIVE 611 Configuration Manual (PJU) - - 05/2008 Edition
HongKong|UK|China
www.aotewell.com
Interface overview, 5 kW UI modules, continued
Function
Signaling contact
Line contactor
FR+
Setup/normal operation
Contactor control
Coil contact for
line supply, pre- -charging
M
contactor
:
only use copper cables dimensioned for an operating temperature ≥ 60˚C.
Notice
There are no 7, 45, 44 and 10 terminals for the 5 kW UI module.
sales@aotewell.com
Type
Typ. voltage/limit values
1)
I 1- -ph. 250 V AC/50 V DC/2 A
NC 17 V DC/3 mA min
O +24 V
I +13 V...30 V/R = 1.5 kΩ
E
I +13 V...30 V/R = 1.5 kΩ
E
O +24 V
I 0/+24 V
O 0 V
Industry Automation
6 Infeed Modules
6.5 Interface overview
Max. cross- - section
6)
7) 2
1.5 mm
2
1.5 mm
max. cable length,
30 m
2
1.5 mm
2
1.5 mm
2
1.5 mm
2
1.5 mm
2
1.5 mm
2
1.5 mm
6-175
+86-755-8660-6182
6