Clear Cmos (Jbt1); Pci Slot Smb Enable (Ji2C1/Ji2C2) - Supermicro X10SRG-F User Manual

X10SRG-F Motherboard User's Manual

Clear CMOS (JBT1)

JBT1 is used to clear CMOS. Instead of pins, this "jumper" consists of contact pads
to prevent accidental clearing of CMOS. To clear CMOS, use a metal object such
as a small screwdriver to touch both pads at the same time to short the connection.
Always remove the AC power cord from the system before clearing CMOS.
Important: For an ATX power supply, you must completely shut down the
system, remove the AC power cord and then short JBT1 to clear CMOS.

PCI Slot SMB Enable (JI2C1/JI2C2)

Use Jumpers JI2C2/JI2C3 to enable PCI
SMB (System Management Bus) support
to improve system management for the
PCI slots. See the table on the right for
jumper settings.
LE1
JUIDB1
UID-SW
SXB1A
1
COM1
VGA
COM2
BMC
LEDM1
JBRSET1
JSTBY1
LE2
BT1
SP1
C
B
A
Intel C610
JBT1
X10SRG-F
REV:1.01
DESIGNED IN USA
CPU
2-30
1
PCI Slot SMB Enable (JI2C)
Jumper Settings
Setting
Short
Open
A. Clear CMOS
B. JI2C1
C. JI2C2
4
LAN2 LAN1
USB 0/1(3.0)
IPMI_LAN
SXB2A
i350
JPL1
JPG1
USB 4/5
USB 6/7
USB 8/9(3.0)
JITP1
Definition
Enabled (Default)
Disabled