Clear Cmos (Jbt1), (S8); Pci Slot Smb Enable (I C1/I C2) - Supermicro Supero C7Z97-M User Manual

Clear CMOS (JBT1), (S8)

JBT1 and the S8 Button is used to clear the saved system setup configu-
ration stored in the CMOS chip. For JBT1, to clear the contents of the
CMOS, completely shut down the system, remove the AC power cord and
then short JBT1 with a metallic object such as a screwdriver. For the S8
Button, shut off the system and press this button.
Any of these two will erase all user settings and revert everything to
their factory-set defaults.
Note: On the C7Z97-MF, the boot time immediately after clearing the
CMOS may take longer due to additonal IPMI functions.
PCI Slot SMB Enable (I
Use Jumpers I
2
SMB (System Management Bus) support
to improve system management for the
PCI slots. See the table on the right for
jumper settings.
B
JL2
JI2C1
JI2C2
C
A
JBT1
S8
D
S11
JF1
JSD1 I-SATA0
C1/I
2 2
C1/I C2 to enable PCI
2
HD AUDIO
FAN5
BIOS
LICENSE
JD1
I-SATA1 I-SATA3
FAN3
2-29
C2)
Jumper Setting
Short
Open (Default)
A. Clear CMOS
B. JI
C. JI
D. Clear CMOS Button
HDMI/DP
LAN
USB 12/13
(3.0)
USB 2/3
(3.0)
JPL1
C7Z97-M
Rev. 1.00
USB8/9(3.0)
JPW1
I-SATA1 I-SATA3 I-SATA5
I-SATA0 I-SATA2 I-SATA4
Chapter 2: Installation
PCI Slot_SMB Enable
Jumper Settings
Definition
Enabled
Disabled
C1
2
C2
2
USB 0/1
VGA(IPMI)
KB/MOUSE
JPW2
S4
DIMMA1
DIMMA2
DIMMB1
DIMMB2
FAN2