A3 ADC/DSP Board Replacement
Tools Required
•
TORX screwdriver, T10, T15, and T20
•
Flat edge screwdriver
•
Open-end torque wrench, 5/16 inch (set to 10 in-lb) (for reconnecting SMA connector)
Removal Procedure
Refer to Figure 6-15 for this procedure.
Step 1. Remove the outer cover as described in "Outer Cover Removal" on page 176
Step 2. Remove the front panel as described in "Front Panel Removal" on page 178.
Step 3. Remove two TORX T10 screws (item 1).
Step 4. Disconnect the RF cables (item 2).
Step 5. Slide out the ADC/DSP board (item 3).
Figure 6-15
A3 ADC/DSP Board Removal
Replacement Procedure
Step 1. Reverse the order of the removal procedure.
NOTE
Fasten the semi rigid cable using a torque wrench for replacement.
Chapter 6
Replacement Procedure
A3 ADC/DSP Board Replacement
197