Replacement Procedure
BNC Connector(front) Replacement
BNC Connector(front) Replacement
Tools Required
•
TORX screwdriver, T10, T15, and T20
•
Open-end torque wrench, 5/16 inch (set to 10 in-lb) (for reconnecting SMA connector)
•
Open-end wrench, 3/8 inch
•
Flat edge screwdriver
Removal Procedure
Refer to Figure 6-29 for this procedure.
Step 1. Remove the outer cover as described in "Outer Cover Removal" on page 176.
Step 2. Remove the front panel as described in"Front Panel Removal" on page 178.
Step 3. Remove the DC Source board as described in"A2 DC Source Board Replacement" on
page 195.
Step 4. Cut the cable tie (item 1) which ties cable.
Step 5. Remove the two TORX T10 screws (item 2) fastening the angle.
Step 6. Remove the three cable assembly (item 3) fastening the angle.
Step 7. If the diode is to be replaced, unsolder the diode (item 4).
Step 8. Remove a 9/16 inch nut (item 5) fastening the angle.
Step 9. Remove the three RF connector (item 6) fastening the angle.
218
Chapter 6