Creating A User Profile; Configuring A User Profile; Configuration Guidelines; Configuration Procedure - HP 3600 v2 Series Security Configuration Manual

Creating a user profile

Follow these steps to create a user profile:
To do...
Enter system view
Create a user profile, and
enter its view

Configuring a user profile

Configuration guidelines

After a user profile is created, apply a QoS policy in user profile view to implement restrictions on
•
online users. The QoS policy takes effect when the user profile is enabled and a user using the user
profile goes online.
The QoS policies that can be applied to user profiles support only the remark, car, and filter
•
actions.
Do not apply an empty policy in user profile view because a user profile with an empty policy
•
applied cannot be enabled.
If a user profile is enabled, you cannot change the QoS policy or edit any QoS policy content
•
(including the ACL that is referenced by the QoS policy).
For information about QoS policy configurations, see ACL and QoS Configuration Guide.
•

Configuration procedure

Follow these steps to configure a user profile:
To do...
Enter system view
Enter user profile view
Apply the QoS policy
Use the command...
system-view
user-profile profile-name
Use the command...
system-view
user-profile profile-name
qos apply policy policy-name
{ inbound | outbound }
223
Remarks
—
Required
You can use the command to enter the view of
an existing user profile.
Remarks
—
Required
Required
The inbound keyword applies the
QoS policy to incoming traffic of the
switch (traffic sent by online users).
The outbound keyword applies the
QoS policy to outgoing traffic of the
switch (traffic sent to online users).