Displaying And Maintaining Ipsec; Ipsec For Ripng Configuration Example - HP 3600 v2 Series Security Configuration Manual

NOTE:
A manual IPsec policy can reference only one IPsec proposal. To change an IPsec proposal for an IPsec
•
policy, you must remove the proposal reference first.
• If you configure a key in two modes: string and hexadecimal, only the last configured one will be used.

Displaying and maintaining IPsec

To do...
Display IPsec policy information
Display IPsec proposal
information
Display IPsec SA information
Display IPsec packet statistics
Clear SAs
Clear IPsec statistics

IPsec for RIPng configuration example

NOTE:
The IPsec configuration procedures for protecting OSPFv3 and IPv6 BGP are similar. For more information
about RIPng, OSPFv3, and IPv6 BGP, see
switches support IPsec for OSPFv3 and IPv6 BGP.
Network requirements
As shown in
information through RIPng.
Configure IPsec for RIPng so that RIPng packets exchanged between the switches are transmitted through
an IPsec tunnel. Configure IPsec to use the security protocol ESP, the encryption algorithm DES, and the
authentication algorithm SHA1-HMAC-96.
Figure 100 Network diagram
Use the command...
display ipsec policy [ brief | name policy-name
[ seq-number ] ] [ | { begin | exclude | include }
regular-expression ]
display ipsec proposal [ proposal-name ] [ |
{ begin | exclude | include }
regular-expression ]
display ipsec sa [ brief | policy policy-name
[ seq-number ] ] [ | { begin | exclude | include }
regular-expression ]
display ipsec statistics [ | { begin | exclude |
include } regular-expression ]
reset ipsec sa [ policy policy-name
[ seq-number ] ]
reset ipsec statistics
Figure 100, Switch A, Switch B, and Switch C are connected. They learn IPv6 routing
Layer 3 IP Routing Configuration Guide
—
267
Remarks
Available in any view
Available in any view
Available in any view
Available in any view
Available in user view
Available in user view
. Only the 3600 v2 EI