HP 3600 v2 Series Security Configuration Manual page 230

1234-0300-0012
1234-0300-0013
# Display 802.1X authentication information.
<Device> display dot1x interface ethernet 1/0/1
Equipment 802.1X protocol is enabled
CHAP authentication is enabled
EAD quick deploy is disabled
Configuration: Transmit Period
Quiet Period
Supp Timeout
The maximal retransmitting times
EAD quick deploy configuration:
EAD timeout:
Total maximum 802.1X user resource number is 2048 per slot
Total current used 802.1X resource number is 1
Ethernet1/0/1 is link-up
802.1X protocol is enabled
Handshake is enabled
Handshake secure is disabled
802.1X unicast-trigger is enabled
Periodic reauthentication is disabled
The port is an authenticator
Authentication Mode is Auto
Port Control Type is Mac-based
802.1X Multicast-trigger is enabled
Mandatory authentication domain: NOT configured
Guest VLAN: NOT configured
Auth-Fail VLAN: NOT configured
Max number of on-line users is 2048
EAPOL Packet: Tx 16331, Rx 102
Sent EAP Request/Identity Packets : 16316
EAP Request/Challenge Packets: 6
EAP Success Packets: 4, Fail Packets: 5
Received EAPOL Start Packets : 6
EAPOL LogOff Packets: 2
EAP Response/Identity Packets : 80
EAP Response/Challenge Packets: 6
Error Packets: 0
1. Authenticated user : MAC address: 0002-0000-0011
Controlled User(s) amount to 1
As NTK is enabled, frames with unknown destination MAC addresses, multicast addresses, and
broadcast addresses will be discarded.
MAC_AUTHENTICATOR_SUCCESS
MAC_AUTHENTICATOR_SUCCESS
30 s,
60 s,
30 s,
30m
219
14
15
Handshake Period
Quiet Period Timer is disabled
Server Timeout
2
15 s
100 s