Setting The Port Security Mode; Configuration Prerequisites; Configuration Procedure - HP 3600 v2 Series Security Configuration Manual

To do...
Set the limit of port security on the
number of MAC addresses
NOTE:
The port security's limit on the number of MAC addresses on a port is independent of the MAC learning
limit described in MAC address table configuration in the

Setting the port security mode

Configuration prerequisites

Before you set a port security mode for a port, complete the following tasks:
Disable 802.1X and MAC authentication.
•
• Check that the port does not belong to any aggregation group or service loopback group.
If you are configuring the autoLearn mode, set port security's limit on the number of MAC addresses.
•
You cannot change the setting when the port is operating in autoLearn mode.
NOTE:
• You can specify a port security mode when port security is disabled, but your configuration cannot take
effect.
You cannot change the port security mode of a port when online users are present.
•

Configuration procedure

Follow these steps to enable a port security mode:
To do...
Enter system view
Set an OUI value for user
authentication
Enter Layer 2 Ethernet
interface view
Use the command...
port-security max-mac-count
count-value
Use the command...
system-view
port-security oui oui-value index
index-value
interface interface-type
interface-number
205
Remarks
Required
Not limited by default
Layer 2—LAN Switching Configuration Guide
Remarks
—
Required for the userlogin-withoui
mode
Not configured by default.
To set multiple OUI values, repeat this
step.
—
.