[Switch-luser-test] authorization-attribute level 0
[Switch-luser-test] quit
# Configure the password for local privilege level switching authentication to 654321.
[Switch] super password simple 654321
[Switch] quit
Configure the HWTACACS server
2.
NOTE:
The HWTACACS server in this example runs ACSv4.0.
Add a user named test on the HWTACACS server and configure advanced attributes for the user as
shown in
Figure
32:
Select Max Privilege for any AAA Client and set the privilege level to level 3. After these
•
configurations, the user needs to use the password enabpass when switching to level 1, level 2, or
level 3.
•
Select Use separate password and specify the password as enabpass.
Figure 32 Configure advanced attributes for the Telnet user
Verify the configuration
3.
After you complete the configuration, the Telnet user should be able to telnet to the switch and use
username test@bbb and password aabbcc to enter the user interface of the switch, and access all level
0 commands.
<Switch> telnet 192.168.1.70
Trying 192.168.1.70 ...
Press CTRL+K to abort
72