HP 3600 v2 Series Security Configuration Manual page 316

[Switch-luser-client002] quit
# Configure the user authentication method as password and service type as SFTP.
[Switch] ssh user client002 service-type sftp authentication-type password
Establish a connection between the SFTP client and the SFTP server.
2.
NOTE:
The switch supports a variety of SFTP client software. The following uses PSFTP of PuTTy Version 0.58 as
•
an example.
PSFTP supports only password authentication.
•
# Establish a connection to the remote SFTP server.
Run the psftp.exe to launch the client interface as shown in
open 192.168.1.45
Enter username client002 and password aabbcc as prompted to log in to the SFTP server.
Figure 115 SFTP client interface
Figure 1 15, and enter the following command:
305