HP 3600 v2 Series Security Configuration Manual page 45

Specifying the HWTACACS authentication servers
You can specify one primary authentication server and up to one secondary authentication server for an
HWTACACS scheme. When the primary server is not available, the secondary server is used, if any. In
a scenario where redundancy is not required, specify only the primary server.
Follow these steps to specify HWTACACS authentication servers for an HWTACACS scheme:
To do...
Enter system view
Enter HWTACACS scheme
view
Specify the primary
HWTACACS authentication
server
Specify the secondary
HWTACACS authentication
server
NOTE:
• An HWTACACS server can function as the primary authentication server of one scheme and as the
secondary authentication server of another scheme at the same time.
The IP addresses of the primary and secondary authentication servers cannot be the same. Otherwise,
•
the configuration fails.
You can remove an authentication server only when no active TCP connection for sending authentication
•
packets is using it.
Specifying the HWTACACS authorization servers
You can specify one primary authorization server and up to one secondary authorization server for an
HWTACACS scheme. When the primary server is not available, the secondary server is used, if any. In
a scenario where redundancy is not required, specify only the primary server.
Follow these steps to specify HWTACACS authorization servers for an HWTACACS scheme:
To do...
Enter system view
Enter HWTACACS scheme
view
Specify the primary
HWTACACS authorization
server
Specify the secondary
HWTACACS authorization
server
Use the command...
system-view
hwtacacs scheme hwtacacs-scheme-name
primary authentication ip-address
[ port-number | vpn-instance
vpn-instance-name ] *
secondary authentication ip-address
[ port-number | vpn-instance
vpn-instance-name ] *
Use the command...
system-view
hwtacacs scheme
hwtacacs-scheme-name
primary authorization ip-address
[ port-number | vpn-instance
vpn-instance-name ] *
secondary authorization ip-address
[ port-number | vpn-instance
vpn-instance-name ] *
34
Remarks
—
—
Required
Configure at least one
command.
No authentication server is
specified by default.
Remarks
—
—
Required
Configure at least one command.
No authorization server is
specified by default.