Precor GEN06 Series C952 Service Manual page 56

16. Connect the frame ground wire to the treadmill frame, Make sure to route the cable
using the frame cable clips to secure the able in position. Securely tighten the mounting
screw to ensure very good electrical connectivity.
17. Connect the Lift Motor connector to the INCLINE connector on the power control mod-
ule. Make sure to route and use the frame cable clips to safely secure the cable away
from the jack screw.
18. Connect the Lift Motor connector to the LIFT connector on the motor control module.
Make sure to route and use the frame cable clips to safely secure the cable away from
the jack screw.
19. Return the treadmill to the upright position.
20. Level the Treadmill.
21. Install the hood.
22. Plug in the power cord and Switch the input power to ON.
23. Verify the treadmill incline operation through the full range of motion. Do the
Validation - Diagnostic Tests (51765761)" on page 13
24. Verify treadmill operation (see
See Also
"Replacement Procedures" on page 29
"Lift Motor Calibration" on page 24
(Undefined variable: TRM700-16Base.ServiceManualTitle)
"Operation Verification" on
5 Replacement Procedures
Incline Lift Motor Replacement
- INCLINE TEST diagnostic test.
page 8) and return to service.
"Hardware
50