Precor GEN06 Series C952 Service Manual page 20

DIAGNOSTIC
TEST
Belt Test
Auto Stop Test
Incline Test
Stop Key Test
P80 Series Consoles:
On P80 consoles, Diagnostic Tests are located on the Diagnostic tests and hardware cal-
ibration page:
Access code 51765761
l
select System Settings
l
Select System Tests
l
Opens Diagnostic tests and hardware calibration page, select test from menu.
l
DIAGNOSTIC
TEST
Auto Stop Test
Belt Speed Test
Incline Test
USB Test
Touchscreen Test
Touchscreen Cal-
ibration
Backlight Test
RGB Test
Speaker Test
(Undefined variable: TRM700-16Base.ServiceManualTitle)
Press the back button to exit this test.
Tests the belt speed in 0.1 mph increments showing the required Input
Voltage, Input Current to the treadmill, the Output Voltage, and Drive
Motor current at each speed.
Tests the Auto Stop function showing the averaged foot plants and exerciser
"is detected"/ "is not detected" function. Foot plant averaging delay resets
with each speed change.
Tests the incline & Decline function. Allows you to verify the A/D number at
any incline level and the number of Glitches (communication time between
the LPCA and UPCA).
Tests the Stop Key function for P10 and P30 console s.
Test procedure prompts to press the Stop Button, then disconnect and recon-
nect the Lanyard E-Stop, and then press Stop to reset and exit the test.
Tests the Auto Stop function showing the averaged foot plants and exerciser
"is detected"/ "is not detected" function. Foot plant averaging delay resets
with each speed change.
Tests the belt speed by stepping the speed in 0.1 mph increments and show-
ing the required drive motor current.
Tests the incline & Decline function. Allows you to verify the A/D number at
any incline level and the number of Glitches (communication time between
the LPCA and UPCA).
Shows detected USB devices.
Use finger to draw line across touch-screen. Select Finish to exit.
Touch the cross points on the touch screed to proceed through the calibration
procedure.
Tests the console LEDs. Successively press the OK key to verify each group
of LEDs and verify that all LED's illuminate. Press Back to exit the test.
Test the touch-screen RGB colors. Touch screen to advance through the red,
green, blue, and white colors.
Tests speakers.
Hardware Validation - Diagnostic Tests (51765761)
TEST DESCRIPTION
TEST DESCRIPTION
3 Standard Service Software
14