E-Stop Not Communicating - Precor GEN06 Series C952 Service Manual

E-Stop Not Communicating

The error 37 is generated by the upper PCA in the console when the lower control module
gets into an E-Stop state and the upper PCA in the console did not know about it. The system
uses pin 8 of the data cable to communicate E-Stop states between the console and the lower
control module.
Related Error Codes
E-Stop error code: 37.
Refer to the Error Code Troubleshooting Guide
information.
Procedure
Refer to the Error Code Troubleshooting Guide
information.
See Also
"System Troubleshooting Procedures" on page 74
(Undefined variable: TRM700-16Base.ServiceManualTitle)
for error code description and troubleshooting
for error code description and troubleshooting
6 Troubleshooting
86