Precor GEN06 Series C952 Service Manual page 49

6. Use the drive belt to help lift the roller out of the mounting bracket and then remove the
belt off the drive roller pulley,
7. Remove the drive roller.
Installing the drive roller
8. Insert the replacement drive roller through the running belt. Use running belt to help
lower and slide the drive roller into the mounting bracket.
9. Insert the replacement drive roller through the running belt. Place the drive belt onto the
drive roller pulley and use the drive belt to help lower and slide the drive roller into the
roller mounting bracket. Hand tighten the left and right drive roller mounting bolts.
10. Position the running belt on the rollers so that it is centered and sets square on the deck
from the front drive roller to the rear Take Up Roller.
11. Alternately tighten the left and right drive roller mounting bolts to evenly tighten the roller
until the left mounting bolt reaches the left mount stop. The left mounting bracket stop
sets the roller reference position and the right bolt is used to make final position adjust-
ments. Fully tighten the left mounting bolt against the bracket stop position.
12. Using a measuring tape, measure the distance from the front of the left drive roller shaft
to the front of the frame cross beam. Record this reference distance.
(Undefined variable: TRM700-16Base.ServiceManualTitle)
5 Replacement Procedures
Drive Roller Replacement
43