Precor GEN06 Series C952 Service Manual page 69

19. Check the alignment of the magnet and the auto stop assembly, see
Replacement" on
20. Tighten and torque the Deck mounting bolts to 150 in-lbs (17 N-m).
21. Reinstall the Drive Roller and Drive Belt, see
22. Reinstall the Take Up Roller, see
23. Tension and verify the running belt tracking, see
Adjustment" on
24. Replace the belt guard cover ensuring the tabs are firmly locked into position on the
Take Up Roller shaft, see
25. Replace the end cap, see
New Deck break-in
26. Straddle the running belt and set the speed to 3 mph (5 kph). While holding the treadmill
handles, walk onto the middle of the running belt starting from the back walking to the
front and returning to the back. Repeat walking process 4 times.
(Undefined variable: TRM700-16Base.ServiceManualTitle)
page 32.
"Take Up Roller Replacement" on
page 26.
"End Cap & Belt Guard Cover Replacement" on
"End Cap & Belt Guard Cover Replacement" on
5 Replacement Procedures
Running Belt and Deck Replacement
"Drive Roller Replacement" on
"Running Belt Tension and Tracking
"Auto Stop Sensor
page 42.
page 66.
page 46.
page 46.
63