Operation Verification Checklist - Precor GEN06 Series C952 Service Manual

9. Concentrate on the feel of the running belt, the sound of the drive motor and rollers. Be
on the alert for unusual noises, smells or vibrations.
10. Observe the LED's on the console. Make sure that each LED lights as the information
corresponding to that LED is displayed on the console.
11. Press the INCLINE UP key while viewing the console. Confirm that the running deck
inclines and the incline indicator increments to 15% as the INCLINE UP key is con-
tinually pressed.
12. Press the INCLINE DOWN key while viewing the console. Confirm that the running
deck returns to a level position and the incline indicator decrements to 0% as the
INCLINE DOWN key is pressed. (Depending on the software configuration of the con-
sole, the lowest level of incline can be either 0% or -3%).
13. While the running belt is in motion, press the STOP button and verify the running belt
stops.
14. Restart the running belt and while the running belt is in motion, pull the ESTOP cord
and verify the running belt stops.
15. Press and hold the RESET key for a minimum of 6 seconds and view the error log
again. This time check for any NEW error codes that may have resulted from the veri-
fication tests. Repair any new error codes and repeat the verification tests.
Note that on P80 consoles, go to the Event Log page to view logged errors, see
"Accessing the Service Software" on

Operation Verification Checklist

Use this checklist to track that the verification procedure tests were successfully completed
and that the treadmill operation has been verified:
Check, record, and then clear any errors in the error log.
Verify that all LEDs function properly during the Hardware Validation tests.
Verify that all keys on the keypad function properly during the Hardware Val-
idation tests.
Verify that the heart rate functions normally and displays a valid heart rate.
Verify the running belt drive system functions properly throughout the minimum
to maximum range of control. All drive system components (deck, belts, rollers,
IFT) are free of excessive noise, vibrations, or smells.
Verify the Incline A/D value is approximately 6000+/-500 at 0% incline, the
incline operates within the complete range of the lift when the UP or DOWN
keys are pressed and is free of excessive noise or vibrations.
Verify the STOP button stops the running belt from moving.
Verify that pulling the ESTOP cord stops the running belt from moving.
Check for any new error codes that may have been logged in the error log during
operation verification of the treadmill.
.
(Undefined variable: TRM700-16Base.ServiceManualTitle)
page 10.
2 Operation Verification
Operation Verification Checklist
9