Table of Contents
Advertisement
4.
MOUNTING THE CONSOLE AND CABLING
l)
l)
l)
l)
l)
Mount the Console to secure support inside the cab of the vehicle.
2)
2)
2)
2)
2)
Connect the Control Cable to the plug in the back of the Console. Route the cable
out of the vehicle cab.
Dealer).
3)
3)
3)
Turn AUTO/MAN/OFF switch OFF and route Red and White battery wires to a 12-Volt
3)
3)
battery. Attach White battery wire to the NEGATIVE
Red battery wire directly to the POSITIVE
(DO NOT CONNECT RED AND WHITE WIRES TO THE STARTER)
(DO NOT CONNECT RED AND WHITE WIRES TO THE STARTER)
page 7. (DO NOT CONNECT RED AND WHITE WIRES TO THE STARTER)
(DO NOT CONNECT RED AND WHITE WIRES TO THE STARTER). Secure the battery
(DO NOT CONNECT RED AND WHITE WIRES TO THE STARTER)
wires with plastic cable ties. DO NOT
leads or any other electrical wiring.
installation.
4)
4)
4)
4)
4)
Connect the Speed Sensor to the plug in the back of the Console.
5)
5)
5)
5)
5)
Secure and tie the Speed Sensor Cable and Console Control Cable with plastic cable
ties.
6)
6)
6)
6)
6)
Initial installation of the system is now complete.
(Flow Meter extension cables are available from your
FIGURE 5
NEGATIVE (-) battery terminal, and the
NEGATIVE
NEGATIVE
NEGATIVE
POSITIVE (+) battery terminal. See Figure 6 on
POSITIVE
POSITIVE
POSITIVE
DO NOT tie battery wires close to existing battery
DO NOT
DO NOT
DO NOT
See
6
Appendix 8
for Remote Switch
Hide quick links:
Advertisement
Table of Contents
