Sony BVM-D32E1WA Maintenance Manual page 21

Location and Function of Parts
Function buttons in SHIFT ON mode (LEDs of function buttons in amber)
MONO APT COMB F1 F2 ADDRESS
BLUE
SAFE
16 : 9
SYNC R G B F3 F4
ONLY AREA
18
16:9 button: When this button is pushed in (ON), the aspect
ratio changes to 16:9, and when set to OFF, the aspect
ratio changes to 4:3.
The aspect ratio is fixed to 16:9 when the signal of some
signal formats is input. For details, see "Available Signal
Formats" on page 65.
SYNC button: When this button is pushed in (ON), the
monitor synchronizes to the sync signal input to the SYNC
connectors on the rear panel (EXT SYNC). When set to
OFF, it synchronizes to the sync signal included in the
signals being monitored (INT SYNC).
Notes
• When INT SYNC is selected, use a component or YC
signals including a sync signal on the Y signal, and use
GBR signal including a sync signal on the G signal.
• To monitor serial digital signals, always select INT
SYNC.
BLUE ONLY button: When this button is pushed in (ON), red
and green signals are cut, and only the blue signal is
displayed as a monochrome picture. It makes it easy to
adjust CHROMA and to check VTR noise.
R/G/B buttons: When these buttons are pushed in (ON),
R(red), G(green), and B(blue) beams are cut respectively.
SAFE AREA button: When this button is pushed in (ON), a
safe area is displayed on the screen.
Note
When EXT SYNC is selected, the safe area display possibly
may not be shown in the correct position.
F3/F4 buttons: For future expansion.
Aperture modification frequency for each signal format
Serial digital input
Signal format
SDI HD SDI
575/50I 5 MHz
480/60I 5 MHz
1080/48I 25 MHz**
1080/50I 25 MHz**
575/50P
480/60P
1035/60I 25 MHz
1080/60I 25 MHz
720/60P 25 MHz**
An empty frame in the table means that the signal cannot be input or the aperture modification can not operate
for that signal even if it is input.
The aperture modification frequency is 25 MHz when the signal is input via the analog input/output connectors (equipped
*
as standard).
The BKM-41HD and BKM-42HD with the serial number 2500001 to 2510000 cannot receive the HD SDI signal of the
**
1080/48I, 1080/50I or 720/60P format. To receive the 1080/48I, 1080/50I or 720/60P format signal, consult your
authorized Sony dealer.
Analog input
Composite Component
GBR
(Y/C) (YP P )
B R
5 MHz 5 MHz* *
5 MHz 5 MHz* *
25 MHz 25 MHz
25 MHz 25 MHz
25 MHz 25 MHz
25 MHz 25 MHz
25 MHz 25 MHz
25 MHz 25 MHz
25 MHz 25 MHz
19