Note on using the BKM-41HD/42HD
When input option slots on the rear of the monitor are
already fitted with a BKM-41HD/42HD HD SDI Input
Adaptor (option), do not try to install another adaptor
or the analog input connectors board in the slot to the
HD SDI Input Adaptor
Input option slots
When installing adaptors, moving the analog input
connectors board, or fitting a cover plate over an
unused slot, always fit the BKM41HD/42HD at the
last step of the operation. If a BKM-41HD/42HD is
already installed, remove it temporarily while carrying
out the other operations, then reinstall it last.
Analog input connectors board
Printed in Japan
right or fit a cover plate (see Fig. 1) over that slot.
Doing so may cause the radiation shield (see Fig. 2) of
the BKM-41HD/42HD to be damaged or detached.
Input adaptor, etc.
When installing two or more BKM-41HD/42HD and
BKM-20D/21D adaptors in any combination, first use
the rightmost option slot, then the second rightmost
option slot, and so on. (Before carrying out this
installation operation, make sure that the slot to the
right of the target slot(s) is already fitted with an