Oracle X4 series Administration Manual page 89

a. State
Click the Enabled check box to enable IPv6 network settings.
Autoconfig
b.
When enabled, the IPv6 Stateless autoconfiguration learns the IPv6 address.
c. DHCPv6Autoconfig
When enabled, the DHCPv6 Stateless autoconfiguration learns the DNS and domain
information.
When enabled, the DHCPv6 Stateful autoconfiguration learns the IPv6 addresses and
DNS information.
When enabled, the None state will only set the Link Local address in Oracle ILOM.
d. Static IP Address
This is the static IP address for the SP.
Link-Local IP Address
e.
This is a non-routable address that you can use to connect to the SP from another
IPv6 enabled node on the same network.
f. Gateway
This is the gateway address for IPv6.
g. Dynamic IP List
This field is read-only. Oracle System Assistant gets these values from Oracle ILOM.
5. When you are done, click Apply Settings.
Some changes are applied immediately. Others cannot be applied until the next boot.
Configure SP Network Settings (Oracle System Assistant)
Performing Initial Setup Actions for Server Management 89