Oracle X4 series Administration Manual page 91

From the CLI interface, perform these steps:
■
a. To view the assigned IPv4 and IPv6 network settings on the SP, type:
For IPv4, type:
For IPv6, type:
To view the descriptions about each IPv4 and IPv6 network property,
b.
type:
For IPv4, type:
For IPv6, type:
c.
To modify the IPv4 and IPv6 network properties on the SP, use the set
command.
IPv4 Example:
set /SP/network state=enabled|disabled pendingipdiscovery=static|dhcp
pendingipaddress=value pendingipgateway=value pendingipnetmask=value
IPv6 Example:
set /SP/network/ipv6 state=enabled|disabled pending_static_ipaddress= value/
subnet_mask_valuepending_static_ipgatewayaddress=
For servers that include the enhanced version of Oracle ILOM, the /SP/network/
Note -
state=enabled command does not enable IPv6. Instead, use the command /SP/network/ipv6
state=enabled.
d. To commit pending network changes in Oracle ILOM, type:
set /SP/network commitpending=true
All user sessions on the SP are terminated when you save IP network property changes.
Note -
To log back in to Oracle ILOM, use the newly assigned service processor IP address.
Modify Oracle ILOM SP Network Settings (Oracle ILOM)
show /SP/network
show /SP/network/ipv6
help /SP/network
help /SP/network/ipv6
Performing Initial Setup Actions for Server Management
value
91