Set Power Capping Policy On Server Sp - Oracle X4 series Administration Manual

b. Enter a Target Limit in watts or as a percentage.
The Target Limit should be set between the minimum power drawn by the installed
Note -
hardware components and the maximum power the managed server is permitted to consume
(peak permitted).
c. Enable Power Limiting by selecting the Power Limiting check box.
d. Click Save to apply your changes.
From the CLI to set a power limit and activate the power limit state on the
■
managed server, type:
set /SP/powermgmt/budget pending_power_limit=[ value ]
pendingactivation_state=enabled commit_pending=true
Where the value represents the target limit value in watts or as a percentage.
The Target Limit should be set between the minimum power drawn by the installed
Note -
hardware components and the maximum power the managed server is permitted to consume
(peak permitted).
Set SP Power Target Limit Properties, Oracle ILOM Configuration and Maintenance Guide for
See Also
firmware version 3.1 or 3.2.

Set Power Capping Policy on Server SP

You can define a power capping policy in Oracle Integrated Lights Out Manager (ILOM) to
enforce a power target limit.
Before You Begin
Log in to Oracle ILOM. For instructions on how to log in to Oracle ILOM, see
■
Log In to Oracle ILOM" on page 39.
Setting System and Management Power Policies (Oracle ILOM)
Set Power Capping Policy on Server SP
"Launch and
105