Smartek UCC User Manual page 93

For a quick start (if you are using GigE Vision cameras) it is recommended to only use Gigabit Ethernet
NICs, configured according to Table 48 shown in chapter 7.1.2 - LAN IP Configuration .
In all cases it must be ensured that further NIC's within the PC are not configured for an IP-address
within the same logical network as the NIC for the camera connection.
If none of the connected cameras was found, check the status of the network adapters
and their configuration, as well as the status LEDs on the Ethernet connector of the
Note
camera, described in chapter 3.1 - Ethernet Interface . Make sure everything is plugged
properly and that the firewall settings are not blocking the connection to camera or
CameraSuiteClient.
87
User Manual - twentynine
SMARTEK Vision | User Manual - twentynine | Doc. v1.0.2