Gigabit Ethernet Interface (Gcc); Cabling Requirements - Smartek UCC User Manual

3.1 Gigabit Ethernet Interface (GCC)

The Ethernet Interface provides configuration access to the camera and is also used for image data
transmission. The connector is a standardize RJ45 jack, assigned like shown in Table 11 below.
Ethernet Connector Type
Pin no.
1
2
3
4
5
6
7
8

3.1.1 Cabling Requirements

To connect the camera to a network, at least a straight UTP (Unshielded Twisted Pair) CAT5e cable needs
to be used in environments with low or no EMI. In environments with higher EMI, a STP (Shielded Twisted
Pair) CAT6 cable is recommended. The scheme for Straight-through patch cable is shown on Figure 19.
Table 11: Ethernet connector type and assignment
RJ45
1 OR/WHT
TD+
2 OR
TD-
3 GRN/WHT
RD+
4 BLU
5 BLU/WHT
6 GRN
RD-
7 BRN/WHT
8 BRN
Figure 19: Straight-through cable scheme
RJ45, Ethernet 1000BaseT, 802.3 compliant
Signal
BI_DA+
BI_DA-
BI_DB+
BI_DC+
BI_DC-
BI_DB-
BI_DD+
BI_DD-
OR/WHT 1
GRN/WHT 3
BLU/WHT 5
BRN/WHT 7
28
User Manual - twentynine
Description
Bi-directional pair +A
Bi-directional pair -A
Bi-directional pair +B
Bi-directional pair +C
Bi-directional pair -C
Bi-directional pair -B
Bi-directional pair +D
Bi-directional pair -D
RJ45
TD+
OR 2
TD-
RD+
BLU 4
GRN 6
RD-
BRN 8
SMARTEK Vision | User Manual - twentynine | Doc. v1.0.2