Multiple Regions Of Interest - Smartek UCC User Manual

5.3.1 Multiple Regions of Interest

If a camera supports Multiple Regions of Interest , the parameters RegionSelector , RegionMode and
RegionDestination can be used to select and control each region individually.
Parameter
RegionSelector
RegionMode
RegionDestination
Each ROI defines one horizontal and one vertical stripe in the full resolution image as shown in Figure 41.
The stripes that are overlapping or are located next to each other are merged into one stripe. For example,
horizontal stripe belonging to Region0 (ROI1) and horizontal stripe belonging to Region1 (ROI2) are merged
into HStripe1. The resulting Multiple ROI image will contain all image areas where horizontal and vertical
stripes overlap.
The width of the resulting image is equal to the sum of widths of all vertical stripes:
The height of the resulting image is equal to the sum of widths of all horizontal stripes:
Type
Enumeration
Boolean
Enumeration
Table 27: Multiple Regions of Interest parameters
Figure 41: Multiple Regions of Interest
ImageWidth =
ImageHeight =
Description
Selects the Region of Interest to control
Enables or Disables the selected region
Controls the destination stream of the selected region
VStripe.width
HStripe.width
56
User Manual - twentynine
SMARTEK Vision | User Manual - twentynine | Doc. v1.0.2