Cabling Requirements - Smartek UCC User Manual

3.3.1 Cabling Requirements

A single 6-pin Hirose receptacle is used to power the camera and provide access to its input and output
lines. When assembling the 6 pin Hirose connector on one side of the cable, it must be taken care to
follow the pin arrangement shown in Table 13 (determining pin 1 from the supplied drawing is critical). It is
recommended to use a shielded twisted pair cable to avoid EMI, the maximum length should not exceed
10m.
Note
The 6 pin connector for the cable is a Hirose plug HR10-7P-6S(73) (or equivalent).
Close proximity to strong high-frequency electromagnetic fields should be avoided. It
Note
is recommended to use shielded twisted pair wires to ensure that signals are correctly
transmitted.
An incorrect pin assignment or connector can lead to permanent damages to the camera.
Figure 21: Hirose 6-pin plug connector
31
User Manual - twentynine
6 1
5
2
4 3
SMARTEK Vision | User Manual - twentynine | Doc. v1.0.2