The parameters of the example shown in Figure 41 are listed in Table 28 below. It shows the definition of all
three ROIs.
RegionMode[RegionSelector]
RegionDestination[RegionSelector]
Width[RegionSelector]
Height[RegionSelector]
OffsetX[RegionSelector]
OffsetY[RegionSelector]
When more than one Region of Interest is enabled, "on-the-fly" changes are not allowed even for parameters
that determine the position of the ROI ( OffsetX, OffsetY ) as they might influence the horizontal and vertical
stripes forming the resulting image. "On-the-fly" change of the parameter RegionMode is also not allowed
as it results in enabling or disabling of a Region of Interest .
RegionSelector
Table 28: Multiple Regions of Interest example
ROI 1
"Region0"
"On"
"Stream0"
576
392
160
408
57
User Manual - twentynine
ROI 3
ROI 2
"Region2"
"Region1"
"On"
"Stream0"
"Stream0"
400
520
1000
232
SMARTEK Vision | User Manual - twentynine | Doc. v1.0.2
"On"
360
288
1576
824