Checking The Configuration - Huawei AR1200 Series Configuration Manual - Mpls

Huawei AR1200 Series Enterprise Routers
Configuration Guide - MPLS
Context
Perform the following steps on the interfaces of both ends of the link between the crossing node
of active and standby links and the LDP neighboring node on the active link:
Procedure
Step 1 Run:
system-view
The system view is displayed.
Step 2 Run:
interface interface-type interface-number
The interface view is displayed.
Step 3 Run:
mpls ldp timer igp-sync-delay value
The period of waiting for the LSP setup after the establishment of the LDP session is set.
By default, the value of the delay timer is 10 seconds.
----End

2.7.6 Checking the Configuration

After the configuration of LDP and IGP synchronization, you can view the synchronization and
route management information on interfaces enabled with LDP and IGP synchronization.
Prerequisite
The configurations of the synchronization between LDP and IGP function are complete.
Procedure
l
l
l
----End
Example
l
l
Issue 01 (2011-12-30)
Run the display ospf ldp-sync interface { all | interface-type interface-number } command
to check information about synchronization between LDP and OSPF on the interface.
Run the display isis [ process-id | vpn-instance vpn-instance-name ] ldp-sync interface
command to check information about synchronization between LDP and IS-IS on the
interface.
Run the display rm interface [ interface-type interface-number | vpn-instance vpn-
instance-name ] command to check information about the route management.
If the configurations succeed, run the display ospf ldp-sync or display isis ldp-sync
command. The status of the interface configured with synchronization between LDP and
IGP is Sync-Achieved.
Run the display rm interface command. You can see that the LDP-IS-IS or LDP-OSPF
synchronization is enabled.
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
2 MPLS LDP Configuration
56