Huawei Proprietary And Confidential; Configuring A Remote Ldp Session - Huawei AR1200 Series Configuration Manual - Mpls

Huawei AR1200 Series Enterprise Routers
Configuration Guide - MPLS
mpls ldp
The MPLS-LDP view is displayed.
Step 3 Run:
capability-announcement
The dynamic LDP advertisement capability is enabled.
By default, the dynamic LDP advertisement capability is not enabled.
----End

2.4.4 Configuring a Remote LDP Session

This section describes how to configure a remote LDP session. MPLS and MPLS LDP must be
enabled globally before the remote LDP session is configured.
Context
A remote LDP session can be established between two indirectly connected LSRs or two adjacent
LSRs.
Both a local LDP session and a remote LDP session can be established between two LSRs.
When a local LDP session and a remote LDP session are established between two LSRs, the
configurations that both the local and remote LDP sessions support must be the same.
Procedure
Step 1 Run:
system-view
The system view is displayed.
Step 2 Run:
mpls ldp remote-peer remote-peer-name
A remote MPLS LDP peer is created and the peer MPLS-LDP view is displayed.
Step 3 Run:
remote-ip ip-address
The IP address of the remote MPLS LDP peer is configured.
----End
Issue 01 (2011-12-30)
NOTE
Enabling dynamic LDP advertisement after an LDP session is established will result in reestablishment of
the LDP session.
NOTE
l This IP address must be the LSR ID of the remote MPLS LDP peer. If the LDP LSR ID and the MPLS
LSR ID are different, LDP LSR ID is used.
l Modifying or deleting a configured IP address of a remote peer also deletes the remote LDP session.

Huawei Proprietary and Confidential

Copyright © Huawei Technologies Co., Ltd.
2 MPLS LDP Configuration
32