Huawei AR1200 Series Configuration Manual - Mpls page 85

Huawei AR1200 Series Enterprise Routers
Configuration Guide - MPLS
[LSRC] mpls lsr-id 3.3.3.9
[LSRC] mpls
[LSRC-mpls] quit
[LSRC] mpls ldp
[LSRC-mpls-ldp] quit
Step 3 Specify a remote LDP peer and its IP address on two LSRs at both ends of a remote LDP session.
# Configure LSRA.
[LSRA] mpls ldp remote-peer LSRC
[LSRA-mpls-ldp-remote-lsrc] remote-ip 3.3.3.9
[LSRA-mpls-ldp-remote-lsrc] quit
# Configure LSRC.
[LSRC] mpls ldp remote-peer LSRA
[LSRC-mpls-ldp-remote-lsra] remote-ip 1.1.1.9
[LSRC-mpls-ldp-remote-lsra] quit
Step 4 Verify the configuration.
# After completing the preceding configurations, run the display mpls ldp session command
on each LSR. The command output shows that the remote LDP session between LSRA and
LSRC is in the Operational state.
In the following example, the display on LSRA is used.
[LSRA] display mpls ldp session
LDP Session(s) in Public Network
Codes: LAM(Label Advertisement Mode), SsnAge Unit(DDDD:HH:MM)
A '*' before a session means the session is being deleted.
------------------------------------------------------------------------------
PeerID
------------------------------------------------------------------------------
3.3.3.9:0
------------------------------------------------------------------------------
TOTAL: 1 session(s) Found.
# Run the display mpls ldp remote-peer command on each LSR to view remote LDP peer
information.
In the following example, the display on LSRA is used.
[LSRA] display mpls ldp remote-peer
------------------------------------------------------------------------------
Remote Peer Name
Remote Peer IP
Transport Address : 1.1.1.9
Configured Keepalive Hold Timer : 45 Sec
Configured Keepalive Send Timer : ---
Configured Hello Hold Timer
Negotiated Hello Hold Timer
Configured Hello Send Timer
Configured Delay Timer
Hello Packet sent/received
Remote Peer Deletion Status
Auto-config
------------------------------------------------------------------------------
TOTAL: 1 Peer(s) Found.
----End
Issue 01 (2011-12-30)
Status LAM
Operational DU
LDP Remote Entity Information
: LSRC
: 3.3.3.9
: 45 Sec
: 45 Sec
: ---
: 0 Sec
: 10/7
: No
: ---
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
SsnRole SsnAge
Passive 0000:00:01
LDP ID : 1.1.1.9:0
Entity Status : Active
2 MPLS LDP Configuration
KASent/Rcv
6/6
78