Huawei AR1200 Series Configuration Manual - Mpls page 98

Huawei AR1200 Series Enterprise Routers
Configuration Guide - MPLS
Configuration Roadmap
The configuration roadmap is as follows:
1.
2.
3.
4.
Data Preparation
To complete the configuration, you need the following data:
l
l
Procedure
Step 1 Assign the IP address to and configure OSPF on each interface.
Configure the IP address and mask of each interface, including the loopback interface, as shown
in Figure
interface and to advertise the host route to each LSR ID. The configuration details are not
provided here.
Step 2 Enable MPLS and MPLS LDP in the system view and interface view.
# Configure LSRA.
<LSRA> system-view
[LSRA] mpls lsr-id 1.1.1.9
[LSRA] mpls
[LSRA-mpls] quit
[LSRA] mpls ldp
[LSRA-mpls-ldp] quit
[LSRA] interface ethernet 1/0/0
[LSRA-Ethernet1/0/0] mpls
[LSRA-Ethernet1/0/0] mpls ldp
[LSRA-Ethernet1/0/0] quit
# Configure LSRB.
<LSRB> system-view
[LSRB] mpls lsr-id 2.2.2.9
[LSRB] mpls
[LSRB-mpls] quit
[LSRB] mpls ldp
[LSRB-mpls-ldp] quit
[LSRB] interface ethernet 1/0/0
[LSRB-Ethernet1/0/0] mpls
[LSRB-Ethernet1/0/0] mpls ldp
[LSRB-Ethernet1/0/0] quit
[LSRB] interface ethernet 1/0/1
[LSRB-Ethernet1/0/1] mpls
[LSRB-Ethernet1/0/1] mpls ldp
[LSRB-Ethernet1/0/1] quit
[LSRB] interface ethernet 2/0/0
Issue 01 (2011-12-30)
Configure the IP address and loopback address of each interface.
Configure OSPF to advertise the route to each network segment of each interface and to
advertise the host route to each LSR ID.
Enable MPLS and MPLS LDP in the system view and interface view.
Configure an inbound LDP policy.
IP address of each interface on each LSR as shown in
OSPF area ID
LSR ID of each node
2-10, and configure OSPF to advertise the route to each network segment of each
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
2 MPLS LDP Configuration
Figure 2-10, OSPF process ID, and
91