Checking The Configuration - Huawei AR1200 Series Configuration Manual - Mpls

Huawei AR1200 Series Enterprise Routers
Configuration Guide - MPLS

2.4.6 Checking the Configuration

After configuring a remote LDP session successfully, you can view information about MPLS-
and LDP-enabled interfaces, LDP configurations, LDP session status, LDP peers, and remote
LDP peers.
Prerequisite
The configurations of the remote LDP session are complete.
Procedure
l
l
l
l
----End
Example
Run the display mpls ldp command to view global LDP information, including timers.
<Huawei> display mpls ldp
--------------------------------------------------------------------------
Protocol Version
Graceful Restart
MTU Signaling
Capability-Announcement : On
--------------------------------------------------------------------------
Instance ID
Instance Status
Loop Detection
Label Distribution Mode
Instance Deleting State
Graceful-Delete
--------------------------------------------------------------------------
Run the display mpls ldp interface [ verbose ] command to view LDP-enabled interface
information, including transport addresses and timers.
<Huawei> display mpls ldp interface
LDP Interface Information in Public Network
Codes:LAM(Label Advertisement Mode), IFName(Interface name)
A '*' before an interface means the entity is being deleted.
------------------------------------------------------------------------------
IFName
------------------------------------------------------------------------------
GigabitEthernet1/0/0
------------------------------------------------------------------------------
<Huawei> display mpls ldp interface verbose
Issue 01 (2011-12-30)
Run the display mpls ldp [ all ] [ verbose ] command to check LDP configurations.
Run either of the following commands to check the LDP session status:
– display mpls ldp session [ verbose | peer-id ]
– display mpls ldp session [ all ] [ verbose ]
Run either of the following commands to check information about LDP peers:
– display mpls ldp peer [ verbose | peer-id ]
– display mpls ldp peer [ all ] [ verbose ]
Run the display mpls ldp remote-peer [ remote-peer-name ] command to check
information about remote LDP peers.
Status
Active
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
LDP Global Information
: V1 Neighbor Liveness
: Off FT Reconnect Timer
: On Recovery Timer
Longest-match
LDP Instance Information
: 0 VPN-Instance
: Active LSR ID
: Off Path Vector Limit
: Ordered Label Retention Mode
: No Instance Reseting State : No
: Off Graceful-Delete Timer
LAM TransportAddress
DU 172.17.1.1
2 MPLS LDP Configuration
: 600 Sec
: 300 Sec
: 300 Sec
: On
:
: 4.4.4.4
: 32
: Liberal
: 5 Sec
HelloSent/Rcv
2495/2514
37