YASKAWA Z1000 Quick Start Manual page 15

n Horizontal Suspension of Drive Models 2A0343A, 2A0396A, and 4A0361A to 4A0590A
To make a wire hanger or frame for use when lifting the drive with a crane, lay the drive in a horizontal position and pass a
wire through the holes of the four eye bolts.
NOTICE: Damage to Equipment. When lifting the drive, confirm that the spring washer is fully closed. Failure to comply may deform or
damage the drive when lifted.
A – No space between drive and
Figure 2.7
B – Spring washer fully closed
n
Vertical Suspension of Drive Models 2A0343A, 2A0396A, and 4A0361A to 4A0590A
When vertical suspension of the drive is required in an enclosure panel, change the orientation of the eye bolts for these models
by turning the eye bolts counterclockwise 90 degrees.
u
Drive Dimensions
Refer to the Z1000 AC Drive User Manual TOEP C710616 45 for IP20/NEMA 1, UL Type 1 and IP00/Open-Type
dimensions.
The Z1000 AC Drive User Manual is posted on the Yaskawa website, www.yaskawa.com.
YASKAWA ELECTRIC TOEP C710616 54A YASKAWA AC Drive - Z1000 Quick Start Guide
B
A
washer
Figure i.8 Spring Washer
Figure i.9 Adjusting Angle of Eye Bolts
D
C
C – Space between drive and washer
D – Spring washer open
NOTICE
i.3 Mechanical Installation
15