Ethernet/Ip (Communication Option 2); Description; I/O Device Configuration - Fluke Endurance Series User Manual

Endurance® Series
Users Manual
Errors occurring when configuring and setting the parameters of the fieldbus communicator and
the connected pyrometer modules as well as external errors are reported by the communicator
via channel specific diagnostic.
In productive data exchange between the I/O controller and the fieldbus Endurance
PROFINET IO, one byte IOPS process data qualifiers are available for each module providing
information of the validity of the pyrometer module data (good/ bad). In the event of an error
occurs during operation, the problem-indicator in APDU-Status is set by the communicator and
a diagnostic alarm is additionally transmitted.
8.3.5.1. The error bits of the pyrometer status register (Error code)
Bit

Description

0 Heater temperature over range
1 Heater temperature under range
2 Internal temperature over range
3 Internal temperature under range
4 Wide band detector failure
5 Narrow band detector failure
6 Energy too low
7 Attenuation for failsafe too high
8 Attenuation to activate relay too high
9 Two color temperature under range
10 Two color temperature over range
11 Wide band temperature under range
12 Wide band temperature over range
13 Narrow band temperature under range
14 Narrow band temperature over range
15 Alarm
16 Video overflow
17 Profinet not ready
18 Heater not ready

8.4. Ethernet/IP (Communication Option 2)

Has to be properly described, when all details are clarified
8.4.1. Description
Has to be properly described, when all details are clarified

8.4.2. I/O Device Configuration

Has to be properly described, when all details are clarified
8.4.2.1. GSD File
Has to be properly described, when all details are clarified
62
®