Figure 59: Removing The Fiber Optic Cable From The Optical Head; Figure 60: Removing The Fiber Optic Cable From The Electronics Housing - Fluke Endurance Series User Manual

Innovative high temperature fiber optic infrared pyrometers

Hide thumbs Also See for Endurance Series:

Table of Contents

Figure 59: Removing the Fiber optic Cable from the Optical Head

11.4.1.2. Removing the Fiber Optic Cable from the Electronics Housing

Complete the following steps to disconnect the fiber optic cable from the electronics housing:

1. First loosen the cable connecting sleeve.

2. Loosen the cable receptacle screw to release the cable.

3. Pull cable from electronics enclosure, and immediately place a protective cap over the

end of the fiber optic cable. Do not use adhesive tape on the cable end.

Innovative High Temperature Fiber Optic Infrared Pyrometers

Turn 1.3 mm (0.050") hex

wrench counter clockwise

until cable is loose

Put cable out

Maintenance

First loosen cable

connecting sleeve

Then loosen screw and pull

cable from coupling.

Table of Contents