Connecting The Probe And The Probe Cable; Disconnecting The Probe/Probe Cable - Kanomax Climomaster S-6531-0E User Manual

Connecting the Probe and the Probe Cable

This section describes how to connect the probe or the probe cable
to the main unit.
Make sure that the power is turned OFF when connecting or
disconnecting the probe or the probe cable.
Probe No.

Disconnecting the Probe/Probe Cable

To remove the probe, follow the procedure below:
Make sure that the power is turned OFF when connecting or
disconnecting the probe or the probe cable.
12 Getting Started
actoolsupply.com
1. Align the connector of the probe or
Probe
Number
2. Line up the connector of the probe
Probe Terminal to connect
the Probe/Probe Cable
A
actoolsupply.com
the probe cable with the probe
terminal on the body.
*When connecting the probe, make sure
the probe number faces towards the front
side of the main unit.
and the terminal of the body and
gently push until it clicks.
*DO NOT FORCE in the probe/probe cable
connector to the main body and DO NOT
ROTATE the probe/probe cable once it is
connected. Doing so may cause serious
damage to the instrument.
1. Lightly lift the locking ring of the
probe/probe cable (A, as shown left).
2. Pull the probe/probe cable out
vertically while holding the lock ring
up.
*DO NOT rotate the connector of the
probe/probe cable when it is connected to
the main body. Doing so may cause serious
damage to the instrument.