Connecting The Probe Fixing Jig - Kanomax 1590 User Manual

Connecting the probe fixing jig

Only the probes 0976-03 and 0976-04, 0976-13, 0976-14 can be used to anchor the

probes with the optional probe fixing jig (Model: 1580-90 [in package of 20 sets]). Do not
use any other probe. Otherwise, malfunction or damage may occur.
How to mount/remove the probe to/from the fixing jig, follow the procedure below.
When mounting/removing the probe, do not allow the sensor of the probe to touch the
probe fixing jig or surrounding objects. Do not touch the air velocity sensor. Otherwise,
malfunction or damage may occur.
■Mounting the probe
Place the part of the probe, which is in the red frame as below figure, on the probe
fixing jig and push the probe until you feel a click.
■Removing the probe
As shown in the left photo below, move the cable near the probe fixing jig in the direction
of the air velocity sensor. After that, hold the part of the probe, which is in the red frame
in the right photo below, and pull up.
The mounting angle can change due to the probe tension.
If its angle changes, adjust the mounting angle if needed.
2. Getting Ready to Measure 23